Distress Ink Smooshing – Merci Beaucoup!

Morning everyone! Its FRIDAY……Yay! Today I’m going to share with you a 6 x 6 card I made using the Ink Smooshing technique, its really easy and quick to do, the finished look is amazing, so effective and the thing I like about it most is that it’s LOADS of fun and the outcome is never the same!

I recently purchased a gorgeous stamp set from one of my favourite stamp companies, Clearly Besotted, called Merci Beaucoup, comes with two beautiful roses and has lots of thankful sentiments, can think of lots of ways to create some beautiful cards with this set.  I stamped the single rose onto a piece of watercolour paper with Versamark Ink and heat embossed with a dark bronze embossing powder and then coloured the rose with my Kuretake Zig Clean Color Real Brush markers adding a little water to them to give a softer look.  The colours I used were Green (040), Light Green (041), Light Carmine (021), Carmine Red (022), Wine Red (024) and Yellow (050).  Once the rose was dry I went over it with a coat of Ranger Glossy Accents to give it a shiny look and sprinkled over some fine gold glitter then left it to air dry, once dried I decided to fussy cut it as I didn’t have the co-ordinating die cut.

Next was the fun part, Ink Smooshing……taking a piece of watercolour paper I decided on my Ranger Distress Ink colours, I wanted colours that blended well with my rose, I chose Abandoned Coral, Mustard Seed, Fossilized Amber and a touch of Festive Berries.  You take one ink pad at a time and dab it onto a piece of acetate or plastic and then spritz with water, you simply take the acetate and place onto your paper and smoosh with your fingers, because it’s plastic you can see whereabouts your placing the ink and you can do this in a controlled manner placing the ink exactly where you want it to be.  Then do the same with the other colours so you get the desired look you’re after. You can dry using your heat tool or leave to dry.  I wanted to splash some gold colour onto the top of the ink so I took my Winsor & Newton watercolour paint and mixed a bit of the Ochre Yellow with a drizzle of Winsor & Newton Iridescent Medium (gives a lovely shimmery gold colour) then I dipped a small paintbrush into the mixed colour and dropped / flicked little droplets over my paper.

I stamped two sentiments from the stamp set with Versamark Ink, ‘You’re too Kind’ and ‘Merci beaucoup’ using my Tim Holtz Stamping Platform (this is a great positioning tool for getting stamps exactly where you want them) then heat embossed in gold, adhered the rose on top of the ‘smooshed’ background using my tombow glue then mounted the watercolour paper onto a 6 x 6 cream card base.  Oh I nearly forgot I added a border placing a piece of gold paper I had onto the 6 x 6 card before sticking down my watercolour paper.

And that is today’s card, I hope you like it.  If you have any questions or simply want to leave a comment I would love to hear what you think of this card.  Remember to subscribe to my blog, you will receive notification by email everytime I post, that way you’ll never miss out, just remember to reply to the confirmation email that will be sent to you.   Thanks so much, or should I say ‘Merci Beaucoup’ for popping by, until next time its…..

Hugs from me,

Karen x

 

Products Used

If you would like to buy any of the products used in this post just click on any image below.  Please note that these are affiliate links, I get a small commission at NO EXTRA cost to you.  This just helps me fund the costs of running my blog.  Your support is gratefully appreciated xx

Leave a comment

Zig Colouring – Watercolour / Embossed Card

Hello everyone!  I can’t quite believe that it’s nearly half way through September, so I wanted to share with you a card I made that is bright and cheerful, bringing some of the summertime back!  It was a really quick card to make, I decided to use my Kuretake Zig Clean Colour Real Brush pens on this card as they are a fab water-based marker, ideal for this watercolour embossed technique.  Everytime I mention Zig that Spice Girls song ‘Wannabe’ comes into my head, Zig a Zig ah…..lol!!!

First I trimmed down my watercolour paper to 17.2cm x 12cm and to prep for heat embossing I gave the paper a good rub with my Stampin’ Up Embossing Buddy.  Next I decided on the stamp I was going to use, I chose a beautiful dandelion stamp from Woodware Mini Flowers and using my Versamark Ink I randomly stamped the flower several times over the watercolour paper then sprinkled over my white embossing powder.  Taking my heat tool I heat embossed the flowers, its quite hard to see the flowers at this stage, but its a great technique with watercolour as it stops the markers/paint bleeding out too much.  This is the exciting part, adding colour!  Using my Zigs (there goes that song again!!) I added colour to the middle of the flower then using my Pental Aqua brush pen (its a clear brush pen that you put water into the barrel – can be used instead of paintbrush and water) I brushed the colour out towards the edge of each flower.  Wait until it dries then go back in with more colour in the middle to add a bit of depth to flower.  The colours I used here were Cobalt Blue (031), Yellow (050), Light Carmine (021), Light Green (041), Turquoise Green (042) and Light Violet (081).  I would highly recommend these Zig brush pens, the colours are so vibrant and so easy to use, you can colour without using water if you wanted.

To finish off I added a touch of Kuretake Wink of Stella to each flower to give a bit of sparkle and I popped some coloured stickers onto some of flowers.  Now it was time to add the sentiment, I took a strip of vellum and wrapped around card and stamped the sentiment from Stampin’ Up Happy Scenes onto a piece of the yellow card that I was using for the card base.  Next I adhered my watercolour piece onto a 5 x 7 card base with some foam tape.  I thought yellow was the perfect colour and there you have it, I did say it was bright and cheery!  Hope its brightened up your day!

Thanks for stopping by, if you have any questions or want to leave a comment I’d love to hear from you.   If you’ve not already subscribed to my blog please do so as that way you will get notified of new posts via your email, just confirm to the welcome email that you’ll receive immediately.

Hugs,

Karen x

Products Used

If you would like to purchase any of the products used in this post just click on any image below.  Please note that these are affiliate links, I get a small commission at NO EXTRA COST to you.  This just helps me fund the running of my blog.  Your support is gratefully appreciated xx

Leave a comment

Embossed Baby Card

Happy Thursday folks!  Thanks for dropping by!  Today I made this quick and simple baby card.  Isn’t it just the sweetest?  I adore making baby cards, the colours, stamps, dies, I LOVE LOVE all things with a baby theme.  Anyway I started off with a 6 x 6 (14.8 x 14.8cm – metric size) card base, then trimmed down a front panel to 14.2cm x 14.2cm. You will see I used the polka dot embossing folder on this panel but thought it was best to die cut the card with the love heart first as sometimes die cuts can leave an embossed imprint all around the edge of your cardstock.  I then went ahead and die cut this cute little baby-gro from Clearly Besotted using my BigShot and white embossed it with the co-ordinating stamp outline for the baby-gro and a stamp from Stampin’ Up Made with Love set.

I then took a piece of pink twine and sellotaped it to the back of the heart space of the front panel so its left dangling at this stage.  Next I adhered the front panel to my main card base using double sided foam tape just to give the card a bit of dimension.  Now I could put foam pieces on the back of the the baby-gro so it was securely stuck down so it wouldn’t swing about anymore! Above the heart I adhered a pink glitter star with a glue dot…looks like a fairy wand, perfect for a girl!!!

All I had to do to finish off the front of the card was to put the name of the baby underneath the heart.  I always think it’s nice to put the name on baby cards as it’s such a gorgeous keepsake for the new parents as they could even place inside a frame and have it hanging in the nursery. Alternatively you could always put a different sentiment in place if you wish, such as ‘Congratulations’.  The alphabet dies I used here are the Quinn ABCs from Lawn Fawn.  But I wasn’t finished with it just yet….don’t you always think that something more could be added to the card to finish it off but you think what if I mess it all up and have to start again (nightmare!!).  Well I hummed and hayed…..so there it is, I added some Diamond Stickles to the white space around the baby-gro and I was pleased that I did because for me it finished it off perfectly.

Now to add a sentiment to the inside of the card.  Using my stamping platform from Tim Holtz (which I absolutely adore and woudn’t be without) I used these stamps from the Big News set from Stampin’ Up.  I always think the ‘your little baby is BIG NEWS’  cries out for a little colour so I went ahead and matched up the perfect shade of a Copic marker (R83).  Voila!

 

Hope you enjoyed learning how to put this card together, it really is a quick and simple card to make.  Please feel free to leave any comments, I would love to hear from you.

 

Hugs, Karen x

Leave a comment